ARCHON DH40 WH46 4*CREE XM-L U2 LED Max 4000 Lumens 3 Modes Diving Light with 8*26650 +Charger
Archon WH46 Canister Diving Light
◆ Model: WH46 Canister Diving Light
◆ Bulb: CREE XM-L U2 LED*4 (Max 4000 Lumens)
◆ Color temperature: 6500k.
◆ Three output levels. High> Low>Strobe
◆ Runtime: High: 5.0h, Low: 15.0h, Strobe: 8.0h
◆ Light head: with handheld bracket
◆ Reflector: Glossy Aluminum reflector
◆ Lens: 8mm Polycarbonate Board.
◆ Body material: Durable aircraft-grade aluminum.
◆ Angle of light beam 8° hot spot, 110° periphery
◆ Surface treatment: Premium Type III hard-anodizing.
◆ Color: Black
◆ Battery: rechargeable Li-ion battery pack (26650 battery *8)
◆ Battery Indicator: 100%-50%: Green; 50%-30%: Yellow; 30%-10%:
Red; Below 10%: Red Flashing; Below 5%: switch off;
◆ Can be charged directly on the light, with battery over-discharging
protection, polarity reversing protection
◆ Fully charging time: 8-10h;
◆ With gas release valve
◆ Operation voltage: 12V to 18V;
◆ Waterproof: 100 meters underwater
◆ Dimensions: 244.5mm (canister length)* 78.2mm (dia. Of canister) *
64.5mm (dia. Of light head);
◆ Weight: 2420 grams (with battery pack)
◆ Underwater Weight: 1150 grams (with battery pack)
◆Impact resistance: 1.5M.
1. Plug the charger in the wall power socket, the indicator light is green
in the free-load status.
2. Open the top cover of the canister, plug the plug of the charger in the
ports on the canister. (the positive and negative polar doesn't matter,
both ways work.)
3. The indicator light is on the charger red if the battery is not fully
charged; it will turn green after fully charged.
4. Take out the charger, put the cover on the canister and use the light.
Push the switch to turn it ON.
Successive push the switch ON-OFF within two seconds to cycle through High, Low, strobe, OFF.
SCUBA DIVING APPLICATION
Check closely for cuts, scratches, or an otherwise damaged O-ring or mating lens surface as this can cause the light to flood under pressure. Remove any salt deposits, sand, dirt, or other foreign matter from the O-ring sealing surfaces.
KEEP THE THREADS, O-RING GROOVE LUBRICATED WITH SILICONE GREASE.
Please put the switch on the canister to the position of “OFF” during transportation to prevent it from misoperation.
If the switch gets stuck, please put some washing-up liquid in the slot of the switch and push the switch back and forward several times till it move smoothly again, then clean the light in the fresh water.
Please charge the light every time after using. If it isn't used for a long time, please charge the light once every 3 months to prepare for next time using.